Appro WH300 Betriebsanweisung PDF herunterladen (Seite 13)

Rev. 2.0

1/23/06

Appro WH300 User’s Guide 12

bay. The hard drive bay cage is not externally accessible.

iii) Optional 3.5-inch Hot Swap Drive Bay

The optional hot swap drive bay upgrade kit supports either up to six 3.5-inch SCSI

or six 3.5-inch SATA hot-swap hard drives. Depending on the model chosen, up to

six bays are included with the upgrade kit. If no drive is installed in a carrier, a

plastic air baffle must be installed to ensure proper hard drive cooling.

The hot swap drive bay accepts 1-inch peripherals that consume up to 18 Watts of

power.

3.4 Remove the Access Cover

Observe the safety and ESD precautions at the beginning of this manual. Before removing the

left side cover, power down the server and unplug all peripheral devices and the AC power

cable.

1. If the shipping screws are installed, remove them (letter A in the figure below).

2. Push in on latch with your right hand, and with your left hand, grasp the rear cover

clasp.( letter B in figure below)

3. Slide left side cover rearward to remove from chassis (letter C in the figure), Set the cover

aside..

3.5 Remove the Front Bezel

1. Disengage the two bezel tabs from the left side a chassis. See letter A in the figure.

2. Rotate the left side of the front bezel assembly outward slightly. See letter B in the figure.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 36 37

Keine Kommentare

Appro WH300 Betriebsanweisung Seite 13