Appro SD-7800 Installationsanleitung PDF herunterladen (Seite 17)

7800 Series Keypad Installation Guide 15

Additional Programming

The keypads allow users to present a proximity credential to the built-in proximity

reader. Users can also manually enter their user code into the keypad. The keypad

veries the user code and its authority with the panel. Additionally, the 7873 keypad

activates the on-board Form C relay releasing a door strike or magnetic lock. To

provide added exibility, the 7873 Keypads allow connection of an external Wiegand

output compatible reader.

Preloading Custom Dealer Logo Information

A custom dealer logo and dealer information may be added to the Main Screen of the

keypad prior to being connected to the panel. This procedure requires the use of a

separate 12 Volt power supply for the keypad. Use the following steps:

1. Connect the 12 Volt DC power supply to the keypad.

2. Power up the keypad and the keypad screen displays SYSTEM BUSY.

3. Press COMMAND to display ENTER CODE:.

4. Enter 3577 and press COMMAND to access the Installer Menu.

5. Press KPD OPT to access keypad options menu.

6. Press COMMAND until DEALER LOGO ADD DELETE displays.

7. Insert Micro SD card with dealer logo into the slot on the right side of the keypad.

8. Press ADD. Keypad displays ADDING LOGO SURE? YES NO.

9. Press YES to load dealer logo. Keypad displays ADDING LOGO.

10. When the dealer logo is successfully loaded the keypad displays

ADDING LOGO COMPLETE.

11. Press COMMAND to exit Dealer Logo menu.

12. Keypad displays DEALER INFO ADD DELETE.

13. Press ADD. Keypad displays ADDING INFO SURE? YES NO

14. Press YES to load dealer information. Keypad displays ADDING INFO.

15. When the dealer information is successfully loaded the keypad displays

ADDING INFO COMPLETE.

16. Press COMMAND to exit to Dealer Info menu.

17. Press Stop to exit Installer Menu.

18. Press in and release the micro SD card to eject

Note: If for any reason the logo or information fails to load the keypad displays

BAD FORMAT. Contact DMP Marketing at 1-800-641-4282 or [email protected] for

information about acquiring a logo.

Programming Cards into the System

Access the User Menu by pressing the Keypad icon in the carousel menu on the main

screen, then press CMD until MENU? NO YES displays.

From the User Menu, select USER CODES. Choose ADD. At the ENTER CODE: - display,

present the credential to the reader. The keypad works by reading the 4 to 10-digit

user code from the data sent by the access control reader. For more information,

refer to Entry Cards in the programming section of this document and the panel

User’s Guide section on adding, deleting, and changing user codes.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22

Keine Kommentare

Appro SD-7800 Installationsanleitung Seite 17